So im making a custom intake and im thinking of using this corvette throttle body and converting it
10-25-2007, 07:16 PM
#1
Junior Member
Thread Starter
Join Date: Nov 2005
Posts: 1,598
Likes: 0
Received 0 Likes
on
0 Posts
So im making a custom intake and im thinking of using this corvette throttle body and converting it
to cable pull. If im making a completely new intake plenum, runners, and a flange for this it should work fine right?<ul><li><a href="http://cgi.ebay.com/ebaymotors/Ls2-Ls7-90mm-Ported-Throttle-body-Corvette-GTO-tb_W0QQitemZ120174847539QQihZ002QQcategoryZ33558QQ ssPageNameZWDVWQQrdZ1QQcmdZViewItem">http://cgi.ebay.com/ebaymotors/Ls2-Ls7-90mm-Ported-Throttle-body-Cor
10-25-2007, 07:26 PM
#2
AudiWorld Member
Join Date: Jun 2006
Location: Santa Monica, CA
Posts: 573
Likes: 0
Received 0 Likes
on
0 Posts
"Bump stop mod"?
Can our throttle bodies not open 90 degrees?
I suppose it would work, guessing that there is a similar signal being sent to the TB from a Vett and A4.
I suppose it would work, guessing that there is a similar signal being sent to the TB from a Vett and A4.
Thread
Thread Starter
Forum
Replies
Last Post
Pre95
Audi 5000 / 200 / V8 Discussion
2
12-30-2008 05:55 PM
~DonQPremiumTequila~
S4 / RS4 (B5 Platform) Discussion
4
08-09-2008 05:52 PM
Nate (ETKA+Scumbag)
A4 (B5 Platform) Discussion
7
07-06-2008 05:34 AM