Does anyone have the APR Home Programmer EMCS1 A and B connectors they don't need anymore?
02-10-2005, 01:43 PM
#1
Does anyone have the APR Home Programmer EMCS1 A and B connectors they don't need anymore?
I have a APR home programmer with EMCS2 connector, but want to help out some local APR peeps who have the EMCS1 interface on their chips.
<img src="http://www.goapr.com/Audi/images/emcs1vs2.jpg">
<img src="http://www.goapr.com/Audi/images/emcs1_connectors.jpg">
Thanks!
<img src="http://www.goapr.com/Audi/images/emcs1vs2.jpg">
<img src="http://www.goapr.com/Audi/images/emcs1_connectors.jpg">
Thanks!
02-10-2005, 01:59 PM
#3
Not yet. (more)
FWIW, I do like the MT chip better than the X chip. it's seems a lot smoother, and while I can't turn up boost like it appears I should be able too, adjusting the value up does seem to increase throttle response (especially at low rpms), which is kind of nice.
I'm kind of waiting to see what happens when the temps warm up, plus I plan on playing with some N75 valves too. But the MT chip is only requesting barely 1.0 bar of boost with the boost value turned all the way up. (255). This is in 30-40 degrees ambient. With the boost value at 190, the same boost is requested. (I'm also getting pretty much exactly what's requested).
I'm kind of waiting to see what happens when the temps warm up, plus I plan on playing with some N75 valves too. But the MT chip is only requesting barely 1.0 bar of boost with the boost value turned all the way up. (255). This is in 30-40 degrees ambient. With the boost value at 190, the same boost is requested. (I'm also getting pretty much exactly what's requested).
Thread
Thread Starter
Forum
Replies
Last Post
Tongpo~Dr. Evil
A4 (B6 Platform) Discussion
3
10-28-2003 12:28 PM
Cleared Hot
Performance and Tuning
3
10-20-2003 09:06 AM
B-mike
A4 (B5 Platform) Discussion
9
03-02-2000 09:58 AM