Stratocaster1422

well either way....where is the cheapest place to get a set of triple squares?

Andy_FL

They sell a 3-piece set IIRC, in the "OEM Tools" line. They're not sockets though, just on 1/2"? hex drives. I intended to use the triple square when doing my FF, but this particular set from AZ is too long. So that's why I used the Torx. YMMV though, depending on the conditions that the undercarriage of your car has seen. Good luck

Andy

Stratocaster1422

thanks...I'll pick those up as back up, but I'd like to find the socketed ones too.

mnemonic

Im going to order some redline mt-90 for this weekend also.

Stratocaster1422

ok...make sure you have something to take away your used fluid

ModifiedA4

perhaps you can write a tech article, epecially if you bleed the master cylinder

Matt E.

I just used a Dremel to shorten it to legnth :-)

Stratocaster1422

its the 12mm that is equivalent to the 3357 correct?

Trey R

Ahem! :P

Matt E.

OK, I held the bit as Trey dremeled it to size between breaking disks.