just washed my car and now im throwing a low brake pad light on the dash...
#1
![Default](https://www.audiworld.com/forums/images/icons/icon1.gif)
I finished washing and was driving for like 5 min then the light came on...looks kinda like this (0)...there is still like 1/4-3/16 inch of pad left on each corner...brakes work and feel fine...i shut off car and it went away till i used my brakes again...any ideas??
#4
![Default](https://www.audiworld.com/forums/images/icons/icon1.gif)
if you wash your car after driving it and the brake rotors are very hot... they can warp with the cold water ... not sure if that could effect the sensor in any way though ?
#6
![Default](https://www.audiworld.com/forums/images/icons/icon1.gif)
MB is right, you can warp them if you spray them with cold water while hot, but that would have to a situation where you just drove 20 min at 80mph on the highway and came to stop, got out of your car, and hosed down the wheels/rotors. Think about how many people would have warped rotors if it was because they drove to the wash...most people drive to the car wash and they are fine.
Did you use any wheel cleaner? Maybe you got a good amount of it on your rotors or on your brakes? I dont know, just tossing out an idea.
Did you use any wheel cleaner? Maybe you got a good amount of it on your rotors or on your brakes? I dont know, just tossing out an idea.
#7
![Default](https://www.audiworld.com/forums/images/icons/icon1.gif)
rinsed them off pretty good. Does the light usually go off when there is still that much pad left?