Need help with HomeLink ......
03-25-2002, 10:55 AM
#1
New Member
Thread Starter
Join Date: May 2001
Posts: 457
Likes: 0
Received 0 Likes
on
0 Posts
Need help with HomeLink ......
I have the homelink system and a genie garage door opener. I have reset the homelink system just like the homelink website says. I have programmed the first homelink button just like the audi booklet says. All the lights lightup and flash like the book says they will. So when I press the first button, it does it's little blink thing and then turns solid, but the door doesn't open. arrrrrrrr......
03-25-2002, 10:57 AM
#2
New Member
Join Date: Jan 2002
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
Re: Need help with HomeLink ......
Did you really hold it down....? Like press and hold? Mine won't open with a press/release, I have to hold it down (light solid) until the door opens. Also, car ignition is on..right?
03-25-2002, 11:48 AM
#5
Junior Member
Join Date: Nov 2001
Posts: 1,311
Likes: 0
Received 0 Likes
on
0 Posts
On mine, I had to use the rolling code setup instructions further along in the manual
After doing the initial 'point your remote at the bumper and watch the flashing lights' thing, it was then necessary to remove the garage door opener lamp cover, push the rolling code setup button, then go back to the car and push my selected remote button again.
Hey, it was a bit of a hassle but it's worked fine ever since.
I copied this from a thread on this subject dated 11/16/2001.
Hey, it was a bit of a hassle but it's worked fine ever since.
I copied this from a thread on this subject dated 11/16/2001.
03-25-2002, 12:10 PM
#7
Re: Need help with HomeLink ......
Be careful with Homelink. My garage door has a rolling code, I didn't know that and I killed my homelink trying to program it. Dealer replaced my visor already and it still doesn't work (the light doesn't come on). I need to make an appointment to have them check the wiring.
Trending Topics
03-25-2002, 04:52 PM
#10
New Member
Join Date: Mar 2002
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
Did the same thing last night with my Genie opener... Worked fine! [more]
After the initial programming (at the front bumper) you have to get up on a ladder and remove the lamp cover like NMAudi says. Press the bottom black button on the right side of the genie console (which should be the program button). Then go back to your car and press the homelink button you've chosen.
It worked for me... hope this helps!
It worked for me... hope this helps!