Splitter on one piece USP front. Pics:
#11
![Default](https://www.audiworld.com/forums/images/icons/icon1.gif)
i like the edges and the alignment there. there is just something about the ammount it protrudes. I think once you finish molding and trimming it, it will look good. Especially once paintedd. Please don't think i am knocking it, just commenting. :=)
I can barely make it into my driveway and most parking lots here without anything else below my bumper. There is no way i could drive around here with that carbon fiber 'splitter'. I am somewhat jelous.
I can barely make it into my driveway and most parking lots here without anything else below my bumper. There is no way i could drive around here with that carbon fiber 'splitter'. I am somewhat jelous.
#12
![Default](https://www.audiworld.com/forums/images/icons/icon1.gif)
The more I looked at it, the more I didn't like how it didn't follow the contour of the USP. A few people at AZ also said it needed tucked in more, and while I don't want to tuck in as far as the Kerscher, I was leaning towards trimming it anyhow. Other's opinions just reinforced what I was thinking.
I'll have pics tomorrow as it's too dark now to take them, but the splitter now matches the bumper contour the whole way around. I actually trimmed more off than in the above post where I drew the red line over the pic to show my plans.
If you look straight down over the top bumper, you can't see the splitter sticking out anywhere.
It flows much better now.
As for pulling in to driveway.... I live in western PA, where even 4x4's bottom out, so it will be fun. I already know I have to take my driveway at an extreme angle. Hope I don't forget...
I'll have pics tomorrow as it's too dark now to take them, but the splitter now matches the bumper contour the whole way around. I actually trimmed more off than in the above post where I drew the red line over the pic to show my plans.
If you look straight down over the top bumper, you can't see the splitter sticking out anywhere.
It flows much better now.
As for pulling in to driveway.... I live in western PA, where even 4x4's bottom out, so it will be fun. I already know I have to take my driveway at an extreme angle. Hope I don't forget...
Thread
Thread Starter
Forum
Replies
Last Post
ECS Tuning-Audi
S4 (B8 Platform) Discussion
7
07-26-2018 02:02 PM
ECS Tuning-Audi
Audi A5 / S5 / RS5 Coupe & Cabrio (B8)
3
02-04-2016 08:36 AM