JonDeutsch

Ah, yes, that's actually what I meant by "calibration." Do we see any issues with a dealer doing the entire install if we're not comfy self-installing?
And what kind of OBDEleven coding is required to handle the stalk button?
Thx.

emonium

Hello! I am searching for the same info as you did)) Have you done this retrofit?? Did you need to use extra wires ??

bruce_miranda

Yes you need not only an extra wire from the dashboard fusebox but you also need a new steering wheel stalk to accept that new wire and send it to the new heated steering wheel.

emonium

I have new steering wheel stalk for heating function allready. Waiting for my new steering wheel now)) Do i need to change connector what goes to steering wheel stalk? Or i can put wires in old connector? How many amps the fuse should be? What kind of wire i should use??

bruce_miranda

Check the wiring diagrams. You will need a fuse crimp on one side and the connector crimp on the other side. But the connector is the same.
If you PM me I might have spare parts to make up a harness for you.

emonium

No need, i think i got it ))) But how many amps fuse should be ?? Did you needed to code something ?? Thanks for the reply !!

bruce_miranda

There is no coding needed for the actual Heating function but you do need to reset the steering wheel angle sensor. And if you have active steering then that isn't a small job. If you don't then it can be done using VCDS.

emonium

But how many amps fuse should be ??

emonium

Last question, but very important. Can you please tell me, which pins i need to power on streening wheel stalk connector... Dont find any info about those pins