OEM 10.1 screen conversion
#111
AudiWorld Junior Member
So confirmed, Panasonic settings work. Just be sure to unplug the unit, change the settings and then power up again. Looks great! Dip switch #2 high the rest all low. A big thank you for getting this figured out!
The following users liked this post:
R54 (01-22-2024)
The following users liked this post:
R54 (01-22-2024)
#113
Fixed !!!
was soo stoked when the purple line disappeared 😁
#114
just make sure its this one
#116
AudiWorld Junior Member
Want to check before I purchase the parts. This changeover will work correctly, with no stretched image, for replacing the 7 inch screen size also? I've got the 7" on my 2018 A5.
#117
AudiWorld Member
#118
Hello, I'm new here. I come from South Tyrol, Italy. I installed the Innolux screen. I've seen many people have the screen offset to the right. The Panasonic setting doesn't fit exactly with Innolux. With Innolux, DIP 1 to 4 must be off and DIP 5 must be on. Then you don't have a red line and the image is cut off in the middle and not on the right side.
#119
Hello, I have a question. I installed the 10.1 screen with the Ali module. Everything works fine. But after 25 minutes the screen briefly goes black and after less than a second the image is available again. Is that the case with you too?
#120
AudiWorld Member
The only time my screen ever went black was an Apple Car Play connection issue. Either the usb wire was not fully seated or the wire began to breakdown due to the way it was bent. I have since constructed a phone holder that allows perfect seating (so far) with no strain on the wire.
FYI my wife's Honda CR-V's screen will occasionally black out. I believe it is a Car Play issue.
FYI my wife's Honda CR-V's screen will occasionally black out. I believe it is a Car Play issue.