JoePGT5S

I have completed my belly pan installation using all the necessary fasteners that would have come from the factory. It took a combination of the kit from ECS and a trip to my local Audi dealership to get all the parts I needed. There are actually 35 individual parts required for a complete installation. 9 sets of 3x plastic/nylon parts and 4 pairs of metal parts. The 9 sets of plastic parts are these:
4A0 805 163 (clip) - nine required
4A0 805 121A (dowel) - nine required
4A0 805 137A (washer) - nine required
...... 5 sets of the above are required for attaching the front of the belly pan to the bumper and 2 sets are required to attach each edge of the belly pan into each wheel well.

The 4 sets of metal parts are these:
8D0 805 960 (speed nut) - four required
8D0 805 121 (speed bolt) - four required
...... 2 sets of the above are toward the front of the belly pan and 2 sets are the rear.

Below is a video showing the location of each fastener and what parts are required in each location:
<iframe width="560" height="315" src="http://www.youtube.com/embed/rdo0w3Ydfak" frameborder="0" allowfullscreen></iframe>

.... if the video embedded above doesn't show the link is:
http://youtu.be/rdo0w3Ydfak

Hopes this helps clarify the parts required for a complete belly pan installation.

Thanks,

Joe

Adjuster

Says video is private...

JoePGT5S

Ahhhh, my mistake. Video marked public now. Sorry about that.

Joe

Adjuster

Cool video, it's nice to see someone still has most/all of them.

Mine have gone from complete, to missing in just one oil change/tire change where the shop broke the pan pulling it onto their center point lift.. (Never should do this BTW..)

sonata54

Bought my car used with no belly pan, always was interested in what the belly pan looked like. Thanks for the video Joe