Thoughts on this wheel design.
#21
AudiWorld Super User
What kind of response is that?
So they have had a design problem for 4 years, so it's okay?
I bet if they were supplied with a set of wheels that they couldn't put air in or check the pressure, they wouldn't want them on their car either.
I bet if they were supplied with a set of wheels that they couldn't put air in or check the pressure, they wouldn't want them on their car either.
#23
AudiWorld Senior Member
Thread Starter
Now that you mention it, it looks like the rim..
.. is reversed, i.e. the spokes should be on the other side installed inside the hump where they drilled the valve stem hole.
You guys are correct.
I wish they would just call it a mistake and take them back. What the heck its only one little measley set of wheels to them.
You guys are correct.
I wish they would just call it a mistake and take them back. What the heck its only one little measley set of wheels to them.
#24
Re: No. They put the hole 3" BEHIND the spokes:/
http://forum.e46fanatics.com/showthread.php?t=262301
I searched around and found this 2 piece custom forged wheel with the same valve hole location.
I do not think it is unique to Iforged.
I searched around and found this 2 piece custom forged wheel with the same valve hole location.
I do not think it is unique to Iforged.
Thread
Thread Starter
Forum
Replies
Last Post
enzeder
Audi allroad
9
06-05-2008 05:47 PM
bassed-ndzmorezone5
A4 (B5 Platform) Discussion
7
12-05-2006 03:12 PM
Hidshadows
Audi 90 / 80 / Coupe quattro / Cabriolet
15
03-02-2004 02:51 PM
Can pretty Valve stems be reused? I am getting a wheel repaired and was curious if i needed to order
S4iscool
Wheels & Tires Discussion
4
05-05-2002 10:51 AM