egp320i

Did you only buy tie rod ends? Another downfall and problematic issue is the adjustment bolt gets galled up and cannot be adjusted. This forces you to replace the entire assembly up to the bracket on the rack.

Of course the arms comes with new tie ends.

If you go in for an alignment you might find you need to do it all over again.

The assembly are around $48 bucks here but in CAN I am sure much more.

<a href="http://tinypic.com?ref=2akcric" target="_blank"><img src="http://i49.tinypic.com/2akcric.jpg" border="0" alt="Image and video hosting by TinyPic"></a>

wake212

Yeah i buy only the tie-rod
It was a real job to install she was very rustted : P but i work verry verry hard and it move, both of them ( the tie-rod and the ajusting nut too ) so i will be alright but my messy noise is always there monday i will get the four wheel up on jackstand and we will seek for the bad noise :P

you can be sure that i will tell you my problem when i will found him i just hope it`s not a bearring inside the transmission where the cj joint is

hope to ride my new car soon and thanks for your reply every one