Who is interested in an RS4 style grill for the Allroad? I found a guy that would make them and we
#1
AudiWorld Super User
Thread Starter
Join Date: Jul 2003
Posts: 2,160
Likes: 0
Received 0 Likes
on
0 Posts
Who is interested in an RS4 style grill for the Allroad? I found a guy that would make them and we
could set up a group buy if we had enough interest.
I started to work on it a while back but I had another baby and a new job so it took a backseat.
If you may be interested let me know and I can contact the person and try to get a GB going.
This would match the mesh grilles below and I think would look great.
I started to work on it a while back but I had another baby and a new job so it took a backseat.
If you may be interested let me know and I can contact the person and try to get a GB going.
This would match the mesh grilles below and I think would look great.
#3
AudiWorld Super User
Thread Starter
Join Date: Jul 2003
Posts: 2,160
Likes: 0
Received 0 Likes
on
0 Posts
He charges $50 for his A4 grills. He told me that a protoype woudl cost more
b/c of the time involved but after that it would most likely be between $50-$75.
Anyone know where we can pick up a spare/used grill to send him?
Anyone know where we can pick up a spare/used grill to send him?
#6
I'm game. Had an RS4 on my A4 and it looked good...
IMO not as good as the B5 S4 grille that I switched to, but it still looked good.
RS4 Grille
<img src="http://pictureposter.audiworld.com/81343/rs4_1.jpg">
S4 Grille
<img src="http://pictureposter.audiworld.com/81343/s4_3.jpg">
RS4 Grille
<img src="http://pictureposter.audiworld.com/81343/rs4_1.jpg">
S4 Grille
<img src="http://pictureposter.audiworld.com/81343/s4_3.jpg">
Trending Topics
#9
I'd be on this like a fly on ****. I've always hated that Audi had the diamond mesh but
didn't use it on the allroad to match the lower grilles.
Of course, it'd have to look good. I'm not slapping some ghetto Dremel job on the car.
Of course, it'd have to look good. I'm not slapping some ghetto Dremel job on the car.
#10
AudiWorld Super User
Thread Starter
Join Date: Jul 2003
Posts: 2,160
Likes: 0
Received 0 Likes
on
0 Posts
He uses 18 gauge stainless steel, then primes, paintes & cleared so I don't really have
any problems with chipping.
This was a quote I pulled from his e-mail not from me.
I agree about the ghetto dremel job.
This was a quote I pulled from his e-mail not from me.
I agree about the ghetto dremel job.