Anyone have dyno results for the MRC RS2 software?
#12
![Default](https://www.audiworld.com/forums/images/icons/icon1.gif)
and this is with a relayed FP.<ul><li><a href="https://forums.audiworld.com/s4s6/msgs/149790.phtml">Link to FP relay DIY</a></li></ul>
#15
![Default](https://www.audiworld.com/forums/images/icons/icon1.gif)
Just email me if you'd like more info. My setup is posted in the thread below. BTW, the car ran very well on 91 octane and had a second setting to run 100 octane at the flick of a switch (est. low to mid 300 WHP range).
Cheers,
Cheers,
#17
![Default](https://www.audiworld.com/forums/images/icons/icon1.gif)
for example, MTM had a chip set for RS2 turbo and EM, with stock injectors. It should have a 3bar MAP sensor. If this is the case for you, and you want to go full RS2, then your ecu is half way there. With the 3bar sensor at least.
#18
![Default](https://www.audiworld.com/forums/images/icons/icon1.gif)
BUT, I had it in my hands last Christmas, before I shipped it down to him. The welds and the collector were the sweetest things I have ever seen! Incredible craftsmanship and absolutely perfect beads. They offer a lifetime warranty on it too, though I have yet to hear of a single header cracking - even without a support. Seams like it should be a great unit, but I can keep in touch with you (when I get it back) and let you know how well it survives unbraced.
Cheers,
Cheers,
#19
![Default](https://www.audiworld.com/forums/images/icons/icon1.gif)
motor.
It did look good.
But I also know that Germantoy had to reweld his a few times.Don't recall what brand his was though.
Post a vid once you get your bish up and running though...sounds like an ape !
Hoping to get my 30R b4 the snow hits.
It did look good.
But I also know that Germantoy had to reweld his a few times.Don't recall what brand his was though.
Post a vid once you get your bish up and running though...sounds like an ape !
Hoping to get my 30R b4 the snow hits.
#20
![Default](https://www.audiworld.com/forums/images/icons/icon1.gif)
I will definitely put some videos up as soon as I get her running
. After I get all of the parts back I'll have to run one more full tank through her at low RPMs to finish breaking the motor in, then she'll be good to do some pulls!
Keep us in the loop on how your project goes, Mike.
![Smile](https://www.audiworld.com/forums/images/smilies/smile.gif)
Keep us in the loop on how your project goes, Mike.