Have a few questions about adding a custom sub box w/2 10's....
#1
Have a few questions about adding a custom sub box w/2 10's....
1) do I want to use line level or speaker level inputs on the amp?
2) what's a good amp for around $200 that will drive 2 10" Polks sufficiently in a sealed box?
3) if an amps ratings are 100w x 2 @ 4 ohms and bridged its 200w x 1 @ 4 ohms, could I run two 4 ohm subs in series for an 8 ohm load (since two 4 ohm subs in parallel is 2 ohms)? If so, what would the brideged power be?
Thanks for your help.
2) what's a good amp for around $200 that will drive 2 10" Polks sufficiently in a sealed box?
3) if an amps ratings are 100w x 2 @ 4 ohms and bridged its 200w x 1 @ 4 ohms, could I run two 4 ohm subs in series for an 8 ohm load (since two 4 ohm subs in parallel is 2 ohms)? If so, what would the brideged power be?
Thanks for your help.
Thread
Thread Starter
Forum
Replies
Last Post
silverA4TQM
Audio, Video and Security Discussion
4
09-07-2005 08:58 AM
CTA4AVANT
Audio, Video and Security Discussion
9
01-17-2005 08:37 PM
chris1
Audio, Video and Security Discussion
5
06-24-2001 12:08 AM
ChrisP
Audio, Video and Security Discussion
3
06-20-2001 01:53 PM
qwertyuiop[as
Audio, Video and Security Discussion
0
11-11-2000 08:35 PM