So I tried to replace the rotors and pads on the S4 yesterday...
06-05-2007, 10:17 AM
#11
AudiWorld Super User
Join Date: May 2002
Posts: 21,018
Likes: 0
Received 0 Likes
on
0 Posts
It would be recommended. I would also grab a torch and heat it up afterwards...
then take a braker bar to it and you should be ok....don't be afraid to lean on that bar to break it loose but make sure you have the right socket, preferably 6-point vs. 12-pt, and make sure its on square.
06-06-2007, 01:40 PM
#12
AudiWorld Super User
Join Date: Jul 2003
Posts: 11,301
Likes: 0
Received 0 Likes
on
0 Posts
WD-40 or PB Blaster, propane torch too
Get a 1.5 - 2 foot long piece of pipe to go over your tools/breaker bar to give you extra leverage, you can do it, just take your time. I highly suggest using lots of PB Blaster and letting it soak. And yes, use 6 point sockets vs 12 point, prevent your chances of rounding. 1/2 deep sockets work really well on this area along with a breaker bar, usually present no problem. Impact tools are god though.
Thread
Thread Starter
Forum
Replies
Last Post
kennyc
A4 (B5 Platform) Discussion
17
10-26-2004 09:57 AM
JimmY@RojoCollisioN
S4 / RS4 (B5 Platform) Discussion
1
02-12-2003 07:49 AM
