Swank4

preferably in San Francisco....but I'd be willing to drive too. I have Autospeed's 3" stainless downpipes and Milltek 3" cat-back. I want to remove the neck-down section on the dps (3"->~2") and have some new sections welded directly to the Y-pipe feeding the single 3" cat-back. I also need an O2 bung tapped and welded to one of the downpipes for a wideband O2 setup. TIA.

April

in installing a custom exhaust system for one of our Alfas (the car was apparently designed to be run w/o an exhaust as there is no room for one) and even after a couple of visits to the track, not a rattle or clunk. They also rerouted the exhaust on our truck for towing and installed airbags along with compressor/tank for load leveling. Works great without a glitch.

Call, talk to Rich and tell him I sent you.

Chekm8

tell him some audi drivers referred you.

STaSIS Motorsports

shoot me an e-mail if you like.

Chris129

2nd that. That's my friend's dad's shop.