fonseca_Q5

When I am using the nav the screen only shows me the destination point and not my actual location point. I would assume that like other units that I have used in the past it should show me where I am and continue adjusting along the route. It does give out the proper directions but just shows me the final destination the entire time. Anyone have any feedback on this? I might have a setting that is not turned on or off or something?

Reggie

Press Nav and then setup buttons - Look at what you have turned on there.

The G Man

Go to your navi setup screen and put the mode on 2d map or 3d map instead of destination mode.