stockornot

My next priority on my Ur q is a complete suspension rebuild. I prefer to go with rubber, but poly bushings have not been ruled out. I need advice on sourcing this stuff, especially struts/springs. I DO NOT, DO NOT, DO NOT want lowered Koni yellows. I want to remain stock on height. Any help would be totally appreciated.

ralleyquattro

Bilstein shocks, the best!!

Katman

I've redone my suspension lately.

I'm not sure that you have to go to coilovers or anything drastic, as the 'stock' setup isn't bad. Especially if you upgrade all the components.

I Repalced the a-arm bushings with 'hard' bushings, replaced the front strut mounts with sperical bushings, and replaced the rear strut mounts with an upgraded version.

And of course, installed Bilstein strut inserts all around.

A *definate* improvement over the baked suspension bushings and tired Boge inserts. (oe still? They were orange)

stockornot

Any suggestions on the best place to get the stuff?

Kidquattro

Not mine, junk after two years of sitting : (

quattro v1.0

Personally I think they are as harsh as Konis, and they just dont last. I have replaced low-mileage Bilsteins too many times cuz the seals began leaking...

fusilier

Aren't they rebuildable? do you still have them?

Kidquattro

Yeah, I have a new set of Koni's in the box I'll swap those in for now.

ralleyquattro

Didn't have a problem with mine... btw Ur-q Billies are designed for stock spring height.