Anyone using MTM stage III software on KO4's ?
02-25-2004, 02:35 PM
#3
Member
Join Date: Apr 2000
Posts: 3,341
Likes: 0
Received 0 Likes
on
0 Posts
It ran very well. I worried about running lean even with the 5bar FPR
but I didn't really have any driveability problems and it was well within the safety range as far as EGTs...
I like stage 4 though :-) A little piece of mind with the RS4 injectors, 17-18psi and 30+/- degrees of timing = one nice setup.
Let me know if you have any other questions.
I like stage 4 though :-) A little piece of mind with the RS4 injectors, 17-18psi and 30+/- degrees of timing = one nice setup.
Let me know if you have any other questions.
02-26-2004, 03:40 AM
#6
Member
Join Date: Apr 2000
Posts: 3,341
Likes: 0
Received 0 Likes
on
0 Posts
If I had to guess, I think with K04s it might be closer to 380hp. I would suspect that the STG4 is
about 405-410hp.
I dyno'd my car back on K03s and it dyno'd approximately 350crank hp on the nose, and it was definetly a little faster with K04s.
In all honestly, ya can't really tell there is 'low end' lag, at least not any that I ever felt.
I dyno'd my car back on K03s and it dyno'd approximately 350crank hp on the nose, and it was definetly a little faster with K04s.
In all honestly, ya can't really tell there is 'low end' lag, at least not any that I ever felt.
Thread
Thread Starter
Forum
Replies
Last Post
PrelateBishop
Rocky Mountain Discussion
18
10-11-2006 05:33 AM
00zero
Audi Original "S" Cars
4
06-22-2004 09:04 AM
s4rocket
S4 / RS4 (B5 Platform) Discussion
14
06-18-2003 03:44 PM
s4power
S4 / RS4 (B5 Platform) Discussion
6
05-09-2003 11:32 AM
Scott W
S4 / RS4 (B5 Platform) Discussion
4
09-27-2000 08:28 AM