Can anyone provide feedback on the APR S4 stealth exhaust? Comparisons...
#1
AudiWorld Senior Member
Thread Starter
Join Date: Aug 2001
Posts: 1,158
Likes: 0
Received 0 Likes
on
0 Posts
Can anyone provide feedback on the APR S4 stealth exhaust? Comparisons...
to the AWE Borla, Neuspeed, or Forge/Miltek (single) exhausts in terms of sound, quality, fit?
Thanks in advance,
Andre
Thanks in advance,
Andre
#2
It's quieter than the Borla/Neuspeed and just a little louder than the Miltek.
NashS4 has the new turbo-back exhaust on his car and under normal driving it's quiet. Even when WOT, it's not loud inside the cabin. I was actually impressed with the fitment on his car when I looked at it when his car was on the lift. If I didn't have my Scorpion, I would consider it.
#4
Similar to Milltek, a touch louder maybe. Fitment is top notch. Didn't even have to adjust...
Seems most people with Millteks enjoy the sound but are constantly complaining about fitment or leaking issues. This is why I went with APR, as the sound is virtually the same. The latest revision APR exhaust is really nice (I have it now, and had the previous revision before).
#5
I rode in a tip with KO4 impellers, DPs and 2-muffler APR and it was LOUD! Difficult to talk in the
car. I have stood next to a Milltek single 3" car and it is nice and quiet. No comparison from my experience.
#6
Must not be the "stealth" exhaust then...
I have the same setup (Stage III, APR DPs and exhaust) and it's very quiet. Just about stock quiet when cruising... only really starts snarling under hard throttle.
Trending Topics
#8
No complaints about fitment on my Milltek. Any leaking issues were snuffed out with good clamps.
I put the good clamps on when I installed it, and I've never had to think about it again.
Thread
Thread Starter
Forum
Replies
Last Post
DirtyJerS4
S4 / RS4 (B5 Platform) Discussion
3
10-08-2002 09:50 AM
Pobe
S4 / RS4 (B5 Platform) Discussion
4
03-19-2001 09:52 PM