Just changed my Forge pistons tonight-->
#1
AudiWorld Senior Member
Thread Starter
Just changed my Forge pistons tonight-->
took me about 50 minutes, and I removed them from the car.
My drivers side valve came out easily, but even though the engine was ice cold (not started in 2 days) the valve didn't open and close quickly enough for me. (got a sshhhhhhtuuck!! instead of a positive sshtuck!)
The passenger side valve was practically sealed to the lower half of the attaching hose. Try as I might, I couldn't get that sucker loose. Took me about 20 minutes to break it free without breaking the hose.
Once the new pistons and o-rings were installed, both valves closed faster and more positive than with the nylons in.
Will take a test drive tomorrow to see how it feels.
My drivers side valve came out easily, but even though the engine was ice cold (not started in 2 days) the valve didn't open and close quickly enough for me. (got a sshhhhhhtuuck!! instead of a positive sshtuck!)
The passenger side valve was practically sealed to the lower half of the attaching hose. Try as I might, I couldn't get that sucker loose. Took me about 20 minutes to break it free without breaking the hose.
Once the new pistons and o-rings were installed, both valves closed faster and more positive than with the nylons in.
Will take a test drive tomorrow to see how it feels.
Thread
Thread Starter
Forum
Replies
Last Post
Replaced TT "N" valve with Forge valve. Anyone else think the Forge valve is giNORMOUS?.............
JCJiffy
A4 (B5 Platform) Discussion
2
10-05-2001 03:22 PM
2urbo
S4 / RS4 (B5 Platform) Discussion
3
07-25-2001 05:21 PM
drhaller
A6 / S6 (C5 Platform) Discussion
1
05-22-2001 07:44 PM