need to recode my instrument cluster for an ecu conversion
#1
AudiWorld Senior Member
Thread Starter
Join Date: Jan 2005
Posts: 1,360
Likes: 0
Received 0 Likes
on
0 Posts
need to recode my instrument cluster for an ecu conversion
from "h" to "m" i think.
getting the ABS lights and "incorrect engine code" something or other crap.
will run fine, just annoying.
getting the ABS lights and "incorrect engine code" something or other crap.
will run fine, just annoying.
#2
AWE and Moss have some info on that, go to Instrument cluster in vag and..
go to adaptation, channel 60 I believe and change it from 1052 to zero or visa versa, can;t remember which now which code is for H
#3
here it is...
. Install the new "M" code software.
2. Turn key to the on position.
A. UsingVag-Com go to "Instruments."
B. Go to "Adaptation."
C. To Channel 60 and hit "Read"
D. Change value to "1025," hit save and confirm that the change was recorded.
E. Exit Vag-Com and cycle key. I recommend that you wait a minute and than
clear codes from both the ECU and the instrument cluster.
2. Turn key to the on position.
A. UsingVag-Com go to "Instruments."
B. Go to "Adaptation."
C. To Channel 60 and hit "Read"
D. Change value to "1025," hit save and confirm that the change was recorded.
E. Exit Vag-Com and cycle key. I recommend that you wait a minute and than
clear codes from both the ECU and the instrument cluster.
#7
speaking of which, a friend of mine is running mbox, and one time we were testing
oh his ecu and mine, mine is Hbox, we put mine into his car and we didnt recode, no cel, no christmas lights! is it a must to recode? say from M to H or the other way around?
Thread
Thread Starter
Forum
Replies
Last Post
4Rings::G2 boosted::
A4 (B5 Platform) Discussion
16
09-14-2008 06:50 PM
thecheez
S4 / RS4 (B5 Platform) Discussion
5
04-07-2008 10:40 PM
allroad2point7t
Audi allroad
8
01-22-2004 06:09 PM
2000, 2001, 60, adaptation, audi, channel, cluster, codes, conversion, ecu, instrament, instrument, lowrider, recode, s4