Torx T-35
04-17-2005, 01:46 PM
#4
New Member
Thread Starter
Join Date: Apr 2005
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Re: where have you looked? Sears has them
I have looked in Ace Hardware. Sears, HomeDepot, Snap-On, Mac Tools and a bunch of others after a google search. I have found 30 and 40, not 35. I will check the somewhat local Sears and AutoZone.
Trending Topics
04-17-2005, 02:13 PM
#8
Audiworld Junior Member
Join Date: Dec 2003
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
You don't need a T35 ... but might need a mallet.
I just finished installing the bipipe. The T35 in the install guide is incorrect.
Most AWers say it's a T30, but I used a T27 to remove my headlights w/o any problems.
Seating the bipipe on the TB is bit tough, make sure that you work the driver-side pipe as you push the bipipe onto the throttle body. Having a rubber mallet handy isn't a bad thing, either ... good luck.
Most AWers say it's a T30, but I used a T27 to remove my headlights w/o any problems.
Seating the bipipe on the TB is bit tough, make sure that you work the driver-side pipe as you push the bipipe onto the throttle body. Having a rubber mallet handy isn't a bad thing, either ... good luck.
04-17-2005, 02:26 PM
#9
New Member
Thread Starter
Join Date: Apr 2005
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Re: You don't need a T35 ... but might need a mallet.
I have a T30 and it is too small for headlights. I found a 1/4" hex on line and may go for it and the extension handle. Thanks for the other advice!
04-17-2005, 02:27 PM
#10
New Member
Thread Starter
Join Date: Apr 2005
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Re: T35 is very rarely used. Are you sure it's not a t30 you need?
I have a T-30 and it is too small. You can say that again about them being rare. Checked Ace, PepBoys, AutoZone, Checker and Napa.