I just install a Miltek 90mm exhaust with a ......
#11
You've got to buy the hanger and donut....>>
<center><img src="http://images.fotki.com/v3/photos/7/7305/84319/exhaust_hangar-vi.jpg?1018153484"></center><p>It looks like this. Use the bolts already on the car. About $30
#12
Had the hanger installed on my ALMS when exhaust installed
and have had no problems.....
Here are the part numbers...got the parts from
www.clairparts.com
BRACKET: 8N0 253 461 C
RUBBER:
(225 HP) 1J0 253 147 C
Here are the part numbers...got the parts from
www.clairparts.com
BRACKET: 8N0 253 461 C
RUBBER:
(225 HP) 1J0 253 147 C
#14
I will put the hanger on the car, but...
I did stuff some rubber up between the body pan and the exhaust and it still resonated. I don't hold out much hope. But, I will let you all know the results. Thanks
#16
P.S. if you bought the Milltek from Stratmosphere, give Pete and Bob
a call...they are very responsive to issues ;-) Don't get frustrated...I had a biTTch of a time with spacers and all worked out okay...oops, sounding like Mom gain. Good luck.
#18
Finally found the pic I was looking for...this is the hanger
you are missing...can't believe that wouldn't make a big difference.
<img src="http://pictureposter.audiworld.com/39/centerhanger.jpg">
<img src="http://pictureposter.audiworld.com/39/centerhanger.jpg">
#20
as someone who drove with milltek without the hanger for 5k miles - hanger makes HUGE difference...
especially with the dreaded 3k rpm vibration. i never would have believed it. Also make sure your center pipe is rotated correctly and is pushed back onto the catback pipe all the way.
Thread
Thread Starter
Forum
Replies
Last Post
Cinco_A6
New England Discussion
4
08-14-2008 03:38 AM
A4wheelin
A4 (B6 Platform) Discussion
13
07-22-2005 08:01 PM
NotCrapple
Audi Original "S" Cars
4
03-29-2005 03:48 AM