Replaced MAP sensor, aka thrust sensor all is well...
11-28-2006, 01:20 PM
#1
AudiWorld Senior Member
Thread Starter
Replaced MAP sensor, aka thrust sensor all is well...
Just making this post because I couldn't find any information on it. Of course replacing it is easy it was $100 from www.worldimpex.com and is listed as a "thrust sensor"
The symthoms I was having were I could clear the Low signal (g31) sensor code with the car off and it would come right back on a second latter. and block 115 read an actual pressure of 130mbar. car was stuck in limp mode as well.
so anyone reading this with these problems in the future. hope that helped you. car runs perfect now
The symthoms I was having were I could clear the Low signal (g31) sensor code with the car off and it would come right back on a second latter. and block 115 read an actual pressure of 130mbar. car was stuck in limp mode as well.
so anyone reading this with these problems in the future. hope that helped you. car runs perfect now
Thread
Thread Starter
Forum
Replies
Last Post
91CpeQ
Audi 90 / 80 / Coupe quattro / Cabriolet
2
07-15-2005 11:47 AM
17593-oxygen (lambda) sensor- B2 S1 Internal resistance too high- intermittent. What does this mean?
I AM 2ks4
S4 / RS4 (B5 Platform) Discussion
2
01-30-2005 01:30 PM
