S line Heated and Illuminated Shift Knob Installed - *Warning: Once you go heated you won't go back*
01-01-2006, 02:38 PM
#16
Look here
if you study this all will become clear young grasshopper.
just remember E=IxR
Learn it. Love it. Live it.<ul><li><a href="http://www.the12volt.com/ohm/ohmslaw.asp">click here for knowledge</a></li></ul>
just remember E=IxR
Learn it. Love it. Live it.<ul><li><a href="http://www.the12volt.com/ohm/ohmslaw.asp">click here for knowledge</a></li></ul>
01-01-2006, 08:27 PM
#18
Member
Thread Starter
Join Date: Mar 2005
Posts: 2,638
Likes: 0
Received 0 Likes
on
0 Posts
The S line **** is hollow and very lightweight- I've only seen the raffi *****
but I was under the impression they were solid. I might bump up the wattage. I ordered HR5594R35.3L80E - If I did it again I would have went with a slightly longer heater. Does that help?
01-01-2006, 08:33 PM
#19
Yup, that helps. The Raffi is "solid" - what does yours weigh? I don't have a scale
here, but might bring it to a shipping store to get it weighed so I can compare.
Might way over-watt it too... Then put a timer on. Run it full power for a few minutes to spike up the temp, and trip a relay to some power resistors to reduce the heating power... Whatcha think?
Might way over-watt it too... Then put a timer on. Run it full power for a few minutes to spike up the temp, and trip a relay to some power resistors to reduce the heating power... Whatcha think?
01-02-2006, 05:55 AM
#20
i found a place that carries what i think you used...would these be it?
what size fit into the S-line shift ****?<ul><li><a href="http://www.omega.com/pptst/SRFR_SRFG.html">http://www.omega.com/pptst/SRFR_SRFG.html</a</li></ul>