Are these codes leaning to bad MAF
06-08-2007, 10:52 AM
#1
AudiWorld Member
Thread Starter
Join Date: Nov 2004
Posts: 423
Likes: 0
Received 0 Likes
on
0 Posts
Are these codes leaning to bad MAF
16487 P0103 163
Mass Air Flow Circuit -G70: High Input [Sporadic]
16795 P0411 163
Secondary Air Injection System: Incorrect FLow Detected [Sporadic]
18010 P1602 163
Power Supply (B+) Terminal 30: low Voltage [Sporadic]
17963 P1555 163
Charge Pressure: value above maximum charge pressure [Sporadic]
Mass Air Flow Circuit -G70: High Input [Sporadic]
16795 P0411 163
Secondary Air Injection System: Incorrect FLow Detected [Sporadic]
18010 P1602 163
Power Supply (B+) Terminal 30: low Voltage [Sporadic]
17963 P1555 163
Charge Pressure: value above maximum charge pressure [Sporadic]
06-08-2007, 11:00 AM
#2
check battery first
make sure your battery is good. Autozone will battery check for free.
After that, make sure all your vacuum lines are ok, esp. the one going to the combi valve.
Next we need Vag Com measuring blocks 32 and 2. post results.
After that, make sure all your vacuum lines are ok, esp. the one going to the combi valve.
Next we need Vag Com measuring blocks 32 and 2. post results.
06-08-2007, 11:06 AM
#3
AudiWorld Super User
Join Date: Jun 2006
Posts: 5,540
Likes: 0
Received 0 Likes
on
0 Posts
These can be related to your dv relocation issues >>>
If something is leaking or incorrectly connected.
They are all sporadic so they may not have all happened during the same ignition cycle and didn't happen on the last ignition cycle.
They are all sporadic so they may not have all happened during the same ignition cycle and didn't happen on the last ignition cycle.
06-08-2007, 11:26 AM
#6
AudiWorld Super User
Join Date: Jun 2006
Posts: 5,540
Likes: 0
Received 0 Likes
on
0 Posts
Actually after I did mine (when I did my FMIC) >>>
I occasionally got the MAF high input and high charge pressure codes but they never caused a cel or anything noticable. This is when I added the **** and the codes never came back.
06-08-2007, 11:35 AM
#7
Cooler air= more efficient boost= higher PSI (until it stabilizes)...>
Normal to see a bit higher boost after a mod like that for the above reason...Usually it will drop a bit lower than it was due to the pressure drop inherrent with the bigger Charge cooling capacity. A Boost Machine will tweek that back easily..
Trending Topics
06-08-2007, 11:40 AM
#8
AudiWorld Super User
Join Date: Jun 2006
Posts: 5,540
Likes: 0
Received 0 Likes
on
0 Posts
This was a year ago, it's fine now >>>
I gave it a couple of weeks before doing anything, I figured the **** was a nice addition at that point anyway. I still had to do a little tweaking to get my fuel trims back in line because it was running a tad lean.
I also run an n75h valve so some of this didn't surprise me.
I also run an n75h valve so some of this didn't surprise me.